Eos (1F7) V6-3.2L (BUB) (2008)
Vacuum Brake Booster: Service and Repair
Brake Booster Vacuum Sensor
Brake Booster Vacuum Sensor
Removing
-
Remove the battery.
-
Remove the battery carrier.
-
Disconnect electrical connector - 1 - from the brake booster vacuum sensor - 2 -.
-
Insert a screwdriver between the stop and one end of the securing ring into groove of sealing ring.
-
Now press securing ring - 1 - as far out of groove until brake booster vacuum sensor - 2 - can be pulled out of brake booster.
Installing
-
Installation is performed in the reverse order of removal.