Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the brake light switch- 2 - by rotating it 45 degrees toward the left.
-
Remove air channel - 3 -.
-
Remove cover - 4 -.
-
Disconnect the brake pedal from brake booster. Refer to => [ Brake Pedal and Brake Booster Separating ] See: Brake Pedal Assy/Service and
Repair/Brake Pedal and Brake Booster Separating.
-
Remove the nuts - 1 - from the brake booster.
-
Loosen the both upper nuts - 2 - from the mounting bracket.
-
Carefully remove the brake booster from the vehicle.
Installing
-
Installation is performed in the reverse sequence.
Observe the following points when installing:
-
Clip the brake pedal together with brake booster. Refer to => [ Hold ball head of push rod in front of
mounting and push brake pedal in direction of brake booster, so the ball head
engages audibly. ] See: Brake Pedal Assy/Service and Repair/Brake Pedal and Brake Booster Separating.
-
Bleed the brake system. Refer to => [ Brake System Bleeding General Information ] See: Brake Bleeding/Service and Repair/Brake System
Bleeding General Information.
-
Bleed the clutch.