volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Brake Booster Vacuum Sensor|Page 4210 > < Brake Booster Vacuum Sensor|Page 4208
Page 2
background image

-

With engine switched off, press the brake pedal firmly several times (to deplete vacuum).

-

Press and hold the brake pedal with average foot pressure and start the engine. If the brake booster is working properly, the pedal will be felt to
give noticeably under foot (booster assistance becomes effective).

‹› Replace as a unit in the event of malfunction (previously, check all vacuum lines).

‹› Removing and installing, refer to => [ Brake Booster ] See: Brake Booster. 

5

Seal

6

Brake booster vacuum sensor (G483)

‹› Only on vehicles with the hydraulic brake booster.

‹› Removing and installing, refer to => [ Brake Booster Vacuum Sensor ] See: Brake Booster Vacuum Sensor. 

7

Brake master cylinder without brake light switch

‹› Cannot be serviced. Replace as complete unit if malfunctioning.

‹› Removing and installing, refer to => [ Master Cylinder ] See: Hydraulic System/Brake Master Cylinder/Service and Repair/Master Cylinder. 

8

Brake master cylinder with brake light switch

‹› Cannot be serviced. Replace as complete unit if malfunctioning.

‹› Removing and installing, refer to => [ Master Cylinder ] See: Hydraulic System/Brake Master Cylinder/Service and Repair/Master Cylinder. 

9

Brake light switch (F)

‹› Includes brake pedal switch.

‹› On vehicles before 11.06.05, the brake light switch is located on the brake pedal. Refer to => [ Brake Pedal Assembly Overview ] See: Brake

Pedal Assy/Service and Repair/Brake Pedal Assembly Overview.

‹› Removing and installing, refer to => [ Brake Light Switch, from 11.06.05 ] See: Lighting and Horns/Brake Light Switch/Service and Repair. 

10

    Inner Torx bolt, 5 Nm

11

Heat shield

12

Self locking hex nut, 25 Nm

‹› Always replace after removal

13

Brake line, 14 Nm

‹› Master cylinder/secondary piston circuit to hydraulic unit.

14

Brake line, 14 Nm

‹› Master cylinder/primary piston circuit to hydraulic control unit. 

15

Sealing plugs

‹› Lubricate with brake fluid and press into brake fluid reservoir. 

16

Brake fluid reservoir

17

Cap

18

Sealing plugs

‹› Connection for vacuum hose.

Brake Booster Vacuum Sensor|Page 4210 > < Brake Booster Vacuum Sensor|Page 4208