Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the engine cover.
-
Release the control module connector in - direction of arrow 1 - and pull off in - direction of arrow 2 -.
-
Install the brake pedal actuator (VAG 1869/2).
-
Attach the bleeder hose from the bleeder bottles to left front and left rear brake caliper bleeder valves and open the bleeder valves.
-
Press the brake pedal at least 60 mm using the brake pedal actuator (VAG 1869/2).
-
Close the left front and left rear bleeder valves.
-
Do not remove the brake pedal actuator (VAG 1869/2 ).
-
Place sufficient lint free cloths under the control module and hydraulic unit.
Make sure that brake fluid does not come in contact with the electrical terminals.
-
First, mark both brake lines - A and B - from the master cylinder and remove them from the hydraulic unit.
-
Plug the brake lines and threaded holes immediately with sealing plugs from the repair kit part no. 1H0 698 311 A.
-
Mark the brake lines - 1 to 4 - (from the brake calipers) , and remove them from the hydraulic unit.
-
Plug the brake lines and threaded holes immediately with sealing plugs from the repair kit part no. 1H0 698 311 A.
-
Pull the hydraulic unit with control module upward off of the bracket.