Eos (1F7) V6-3.2L (BUB) (2008)
After-Run Coolant Pump: Testing and Inspection
After Run Coolant Pump, Checking
Special tools, testers and auxiliary items required
‹› Voltage Tester (V.A.G 1527B)
‹› Connector Test Set (V.A.G 1594C)
‹› Wiring Diagram
Conditions
‹› The fuses must be OK.
Sequence
-
Remove the noise insulation.
-
Disconnect the 2 pin connector from the after run coolant pump (V51).
-
Connect the contacts of the after run coolant pump to the battery, using adapter cables from the (V.A.G 1594C).
‹› After run coolant pump must run.
If the after run coolant pump does not start running:
-
Replace the after run coolant pump.
If the after run coolant pump does starts running:
-
Turn the ignition off and then on again.
-
Connect the (V.A.G 1527B) and the cables taken from the (V.A.G 1594C) to the connector, which was disconnected from the after run coolant
pump.