Eos (1F7) V6-3.2L (BUB) (2008)
Fan Shroud: Service and Repair
Fan Shroud and Fans
Special tools, testers and auxiliary items required
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
Removing
-
Remove the noise insulation.
-
Unclip the coolant hose from fan shroud.
-
Remove the air duct from the air filter. Refer to => [ Air Filter Housing Overview ] See: Engine/Tune-up and Engine Performance Checks/Air
Cleaner Housing/Service and Repair.
-
Disconnect the harness connector - 1 - and remove the fan shroud bolts - arrows -.
-
Remove the fan shroud with fans.
-
Disconnect the harness connector - 1 - and lay the wires aside.
-
Remove the nuts - arrows - and remove the fans.
Installing
Installation is performed in the reverse order of removal, noting the following: