Eos (1F7) V6-3.2L (BUB) (2008)
Thermostat Housing: Service and Repair
Thermostat Housing
Thermostat Housing
Special tools, testers and auxiliary items required
^
Hose clamp pliers V.A.G. 1921
^
Drip tray for workshop crane VAS 6208
Removing
^
Drain the coolant.
^
Disconnect battery Ground (GND) strap with ignition switched off.
^
Pull off air guide cover - 1 -, disengage clips sideways to do so.
^
Unclip air duct - 2 -.
^
Remove the air filter housing and connecting hose, while doing this remove the bolt - A -, disconnect the connector - B - and remove the spring
clip - C -. Pay attention to the marking - D - when reinstalling.
^
Pull the air filter housing upward.
^
Remove vacuum line -arrow- at variable intake manifold actuator.
^
Remove screws - 1 - and - 2 - and remove vacuum actuator from intake manifold.