Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the coolant pump - A - as shown.
Installing
Installation is performed in the reverse order of removal, noting the following:
-
Lubricate the new O-ring with coolant.
-
Install the coolant pump.
-
Install and tighten coolant pump bolts. Tightening specification: 8 Nm
-
Install the coolant pump pulley. Tightening specification: 20 Nm
-
Raise the engine using the (10 - 222A) and secure it with new bolts.
-
Align the engine mount as follows:
‹› There must be a distance of at least 10 mm - a - present between the engine mount bracket - 2 - and right longitudinal member.