Eos (1F7) V6-3.2L (BUB) (2008)
‹› Lubricate before assembling.
14
Camshaft Position (CMP) Sensor 2 (G163)
‹› For the exhaust camshaft.
‹› Mark the connector belonging to the component before disconnecting.
15
Chain Tensioner
‹› 40 Nm
‹› For the camshaft timing chain - item 9 -.
‹› Only rotate the engine with the chain tensioner installed.
16
Seal
‹› Replace if damaged or leaking
17
Bolt
‹› 8 Nm
18
Seal
‹› For the Camshaft Adjustment Valve 1 - item 11 - and camshaft adjustment valve 1 (exhaust) - item 12 -.
‹› Replace if damaged or leaking.
‹› Installing, refer to => [ Camshaft Front Cover
Seal, Installing ] See: Cylinder Block Assembly/Balance Shaft Chain/Service and Repair.
19
Coolant Thermostat Housing
‹› Overview, refer to => [ Coolant Thermostat Housing Overview ] See: Cooling System/Thermostat/Service and Repair/Coolant Thermostat
Housing Overview.
‹› Coolant hose connection diagram. Refer to => [ Coolant Hose Connection Diagram ] See: Cooling System/Diagrams.
20
Seal
‹› Replace
21
Camshaft Position (CMP) Sensor (G40)
‹› For the intake camshaft.
‹› Mark the connector belonging to the component before disconnecting.
22
Camshaft Front Cover
‹› Can be removed and installed with the engine installed.
‹› Removing and installing, refer to => [ Camshaft Front Cover Overview ] See: Cylinder Block Assembly/Balance Shaft Chain/Service and
Repair.
‹› If only the cover was removed, prepare the cylinder head gasket for installation, refer to => [ Cylinder Head Gasket, Preparing for Assembly ]
See: Service and Repair/Removal and Replacement/Cylinder Head.
‹› With O-ring - item 13 - for the oil passage.
23
Bolt
‹› 60 Nm + 90° (1/4) additional turn.