Eos (1F7) V6-3.2L (BUB) (2008)
‹› Replace
‹› Contact surface of adjuster and bolt head must be dry when installing.
‹› To remove and install, counter hold at the camshaft using a 32 mm open end wrench. Refer to => [ Camshafts ] See: Camshaft, Lifters and
Push Rods/Camshaft/Service and Repair.
24
Exhaust Camshaft Adjuster
‹› Identification: 32A
‹› Only rotate the engine with the camshaft adjuster installed.
‹› Installing, refer to => [ Camshaft Adjuster with Camshaft Timing Chain, Installing ] See: Actuators and Solenoids - Engine/Variable Valve
Timing Actuator/Service and Repair/Camshaft Adjuster With Camshaft Timing Chain, Installing.
25
Guide Rail
‹› for the camshaft timing chain - item 19 -.
‹› Clipped to the control housing.
26
Intake Camshaft Adjuster
‹› Identification: 24E.
‹› Only rotate the engine with the camshaft adjuster installed.
‹› Installing, refer to => [ Camshaft Adjuster with Camshaft Timing Chain, Installing ] See: Actuators and Solenoids - Engine/Variable Valve
Timing Actuator/Service and Repair/Camshaft Adjuster With Camshaft Timing Chain, Installing.
27
Lifting Eye
28
Cylinder Head Gasket
‹› Metal
‹› Replace
‹› Prepare the cylinder head gasket for installation, refer to => [ Cylinder Head Gasket, Preparing for Assembly ] See: Service and
Repair/Removal and Replacement/Cylinder Head.
‹› After replacing, replace the entire amount of coolant.
29
Cylinder Head
‹› Checking for distortion, refer to.
‹› Removing and installing, refer to => [ Cylinder Head ] See: Service and Repair/Removal and Replacement/Cylinder Head.
‹› After replacing, replace the entire amount of coolant.
30
Belt Tensioner
‹› For the ribbed belt.
‹› Removing and installing the ribbed belt. Refer to => [ Ribbed Belt ] See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service
and Repair/Ribbed Belt.
31
Bolt
‹› Replace
‹› Observe the installation instructions and sequence for loosening and tightening. Refer to => [ Cylinder Head ] See: Service and
Repair/Removal and Replacement/Cylinder Head.