Eos (1F7) V6-3.2L (BUB) (2008)
-
Disengage socket - 1 - and pull it off handle part - 2 -.
-
Turn around handle part - 2 - of torque wrench 180° and insert socket again.
-
Set turning direction of torque wrench to left at socket.
-
Insert (V.A.G 1603/1) into generator shaft.
-
Counter hold (VAS 3400) using 17 mm open end wrench.
-
Tighten ribbed belt pulley with freewheel by turning generator driveshaft counterclockwise using (V.A.G 1332) (80 Nm).
-
Tighten all threaded connections to the specification shown in => [ General Tightening Specifications for All Vehicles ] See:
Specifications/Mechanical Specifications/Starting and Charging/System Specifications/General Tightening Specifications For All Vehicles.