Eos (1F7) V6-3.2L (BUB) (2008)
.
‹› Piston and connecting rod overview. Refer to => [ Pistons and Connecting Rod Overview ] See: Cylinder Block Assembly/Piston/Service and
Repair/Pistons and Connecting Rod Overview.
5
Oil Check Valve
‹› Note the installed position.
‹› Clean if badly contaminated.
6
Bolt
‹› 8 Nm
7
Oil Pump Drive Cover
8
O-ring
‹› Replace
‹› Lubricate before assembling.
9
Oil Pump Drive
10
Intermediate Shaft
11
Oil Spray Jet
‹› For crankshaft bearings 2 through 7.
‹› For piston cooling.
‹› Opening pressure: 2.0 bar
‹› See note in => [ Lubrication System ] See: Description and Operation/Lubrication System.
12
Input Shaft
‹› For the oil pump drive.
13
Oil Pump
‹› => [ Oil Pump Overview ] See: Oil Pump/Service and Repair.
14
Bolt
‹› 8 Nm
‹› Install using locking fluid (D 000 600 A2).
15
Bolt
‹› 23 Nm
16
Oil Drain Plug
‹› 30 Nm
‹› Replace if washer is permanent.
17
Oil Pan
‹› Removing and installing, refer to => [ Oil Pan ] See: Oil Pan.
18
Oil Level Thermal Sensor (G266)