Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-654007.png)
-
Tighten the M8 bolts - item 8 -=> [ Bolt ] See: Balance Shaft Chain/Service and Repair to 23 Nm and tighten the M6 stud bolt - item 2 -=> [ Stud
Bolt ] See: Balance Shaft Chain/Service and Repair to 8 Nm.
-
Install the chain tensioner for the camshaft timing chain and tighten it to 40 Nm.
-
Rotate the crankshaft twice in engine rotation direction and check the valve timing again.
-
Install the cylinder head cover and the intake manifold. Refer to => [ Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service
and Repair/Cylinder Head Cover.
Vehicles from 12.08
-
Rotate the crankshaft at the vibration damper bolt in engine rotation direction to the Top Dead Center (TDC) cylinder 1 mark - arrow -.
-
The camshaft lobes - A - for cylinder 1 must face each other.
