Eos (1F7) V6-3.2L (BUB) (2008)
Timing Chain: Service and Repair
Chain Drive Overview
Chain Drive Overview
1
Control Housing
‹› Marks on the control housing, refer to => [ Marks on Control Housing ] See: Cylinder Head Assembly/Testing and Inspection.
‹› Lightly lubricate the contact surfaces of the oil seals before installing.
‹› Removing and installing, refer to => [ Camshafts ] See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair.
‹› Disassembling and assembling, refer to => [ Control Housing Disassembling
and Assembling ] See: Camshaft, Lifters and Push Rods/Service and Repair.
‹› Check the control housing strainer for contamination before installation. Refer to => [ Control Housing, Checking
Strainer for Contaminants ] See: Camshaft, Lifters and Push Rods/Service and Repair.
2
Bolt
‹› 8 Nm
‹› Install using locking fluid (D 000 600 A2).
3
Camshaft Timing Chain
‹› Mark the direction of rotation before removing (installed position).