Eos (1F7) V6-3.2L (BUB) (2008)
‹› Installing, refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
4
Exhaust Camshaft Adjuster
‹› Identification: 32A
‹› Only rotate the engine with the camshaft adjuster installed.
‹› Installing, refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
5
Intermediate Shaft
6
Tensioning Rail
‹› For the camshaft timing chain - item 3 -.
7
Pivot Pin
‹› 18 Nm
8
Chain Tensioner
‹› 40 Nm
‹› For the camshaft timing chain - item 3 -.
‹› Only rotate the engine with the chain tensioner installed.
9
Seal
‹› Replace if damaged or leaking.
10
Sprocket
‹› For the timing chain - item 15 -.
‹› Installing, refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
11
Sprocket
‹› For the camshaft timing chain - item 3 -.
‹› Installing, refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
12
Bolt
‹› 60 Nm + 90° (1/4) additional turn.
‹› Replace
‹› Use counter-holder tool (T10069) to tighten and loosen. Refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate
Shaft and Timing Chains, Installing.
13
Chain Tensioner with Tensioning Rail
‹› For the timing chain - item 15 -.
‹› Before installation release the locking device in the chain tensioner using a small screwdriver and press the tensioning plate against the chain
tensioner.
‹› Only rotate the engine with the chain tensioner installed.
14
Drive Sprocket
‹› Integral part of the crankshaft.