Eos (1F7) V6-3.2L (BUB) (2008)
^
Lubricate oil channel seal O-ring - 1 - and insert in cover.
^
Make sure the fitting sleeves - 2 - and - 3 - are inserted.
^
Insert the sealing ring - 4 - in the cover.
^
Clean old sealing compound from the 3 mm holes in the cylinder head gasket -arrows-.
^
Fill the 3 mm holes in the cylinder head gasket with sealant D 176 501 A1. Coat the sealing surfaces on the cover with sealant D 176 501 A1 and
install the cover immediately.
^
First install all mounting bolts -arrows- and tighten lightly.
^
Then tighten the M8 bolts to 23 Nm and tighten the M6 bolts to 8 Nm.
^
Install the camshaft roller chain tensioner and tighten it to 40 Nm.
^
Turn over crankshaft twice in direction of engine rotation and check valve timing again.
^
Install cylinder head cover and intake manifold.
Intermediate Drive Shaft and Camshaft Drive Timing Chains
Conditions