Eos (1F7) V6-3.2L (BUB) (2008)
‹› Oxygen sensors remain installed.
-
Remove the 7 exhaust manifold nuts from the exhaust manifold - arrows - and remove the washers.
-
Remove the exhaust manifold toward back.
Installing
Installation is performed in the reverse order of removal, noting the following:
‹› Replace gaskets and self locking nuts.
-
Install the intake manifold. Refer to => [ Intake Manifold ] See: Engine/Intake Manifold/Service and Repair/Intake Manifold.
Tightening Specifications
‹› 1 always replace