Eos (1F7) V6-3.2L (BUB) (2008)
‹› Air Flow Door Motor (V71) can only be removed without difficulty in "fresh air mode stop" and installed only in this position. If motor remains
standing in a different position and can no longer be moved electrically into "fresh air mode stop" position, it can only be pulled off and removed
with difficulty.
‹› Position of fresh/recirculating air door must not be changed.
Removing
-
If necessary, switch ignition on, select operating mode " Defrost" on A/C Control Head (E87) (control motor is always set to "fresh air mode"
position in this operating mode) and wait until control motor has reached its "fresh air mode" end position.
-
Switch off ignition.
-
Remove glove compartment.
-
Unclip wiring harness at bracket - A -.
-
Disengage retaining lugs - D - and - E - for bracket - A - on intake housing and remove bracket - A -.
-
Mark connector to Recirculation Door Motor (V113 ) (to rule out an interchange with connector to Air Flow Door Motor (V71)).
-
Remove Air Flow Door Motor (V113). Refer to => [ Recirculation Door Motor ]. See: Recirculation Door Motor
-
Remove positioning motor - A - from air intake shroud.
‹› Connection between control motor toothed gears and air flow door is designed so that control motor can be removed without difficulty only in the
" fresh air mode" position.
‹› If motor is found in a different position and can no longer be moved, motor cannot be simply pulled off, rather it must be loosened first with great