Eos (1F7) V6-3.2L (BUB) (2008)
force from mounting points - B -, ensure that toothed gear - C - is not damaged when doing this.
Installing
‹› Motor as replacement part is delivered in the "fresh air mode " position, only when toothed gear - A - contacts stop - B - can it then be connected
onto toothed gear of fresh/recirculating air door. If a motor was removed in a different position or activated in the removed state, it cannot be
installed.
‹› If toothed gear - A - of motor does not stand at stop - B - "fresh air mode", proceed as follows:
-
Connect motor to vehicle wiring harness.
-
Switch ignition on.
-
Wait until toothed gear - A - of motor reaches stop - B - "fresh air mode".
-
Switch off ignition.
-
Before installing control motor, check bearing of air flow door in intake housing and of toothed gear - C - (air flow door is opened, "fresh air
mode").
-
Connect Air Flow Door Motor (V71) to vehicle wiring harness (make sure connectors are allocated correctly).