Eos (1F7) V6-3.2L (BUB) (2008)
This slides the press holders - 1 - against the mounting head. This allows them to be removed again easily.
-
Turn wheel on tire mounting device so that tire valve/tire pressure sensor - 2 - stands in front of mounting head - 1 -.
CAUTION!
Mounting head - 1 - must not be located in area - a - of tire valve/tire pressure sensor, otherwise the mounting head will damage the tire pressure
sensor.
-
Position mounting head - 1 - in vicinity of tire valve/tire pressure sensor so that tire iron can be put on approximately 30° next to tire valve/tire
pressure sensor - 2 -.
-
Now pry tire bead over mounting finger of mounting head using tire iron - 3 -.
-
In addition, insert a plastic mounting lever - 4 -.
-
Remove tire iron - 3 - again.
-
Using plastic mounting lever - 1 -, hold bead in place over the rim flange from outside and let tire mounting device run clockwise until tire has
been pulled off completely from disc wheel.