Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-518006.png)
Tire bead now slips over the rim flange. Wheel may be turned only as far until mounting head is located just in front of tire valve/tire pressure sensor -
arrow -.
-
Remove press holders from rim flange.
-
Inflate tire to an inflation pressure of max. 3.3 bar (spring pressure).
CAUTION!
If tire beads do not make contact completely on disc wheel edge, pressure must not be increased under any circumstances.
Pre-damage to tire or disc wheel would result.
-
If tire beads do not make contact completely on disc wheel edge, then release air, press off tire bead once more and coat rim flange thoroughly
again with tire mounting paste.
-
Inflate tire to an inflation pressure of max. 3.3 bar (spring pressure).
-
If tire beads make contact on bead seat without problems, then increase inflation pressure to 4 bar to settle tire.
-
Install a new nickel-plated valve insert and fill the tire to the specified pressure.
-
Then balance wheel.
-
Mount the wheel and tighten it to tightening specification. Refer to => [ Wheel Bolt Tightening Specification ] See: Wheel Fastener/Specifications
.
