Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1413017.png)
-
Guide the release tool which fits the terminal housing into release channel on terminal housing.
-
Grasp contact at wire and push it gently into terminal housing - arrow -.
‹› By pushing the contact in the direction of the terminal housing, the contact retaining tab is lifted off the housing shoulder and can be released using
the release tool.
-
At the same time, push release tool in direction of terminal housing and pull the released contact out of terminal housing - arrow -.
-
After removing the contact, release tool can be pulled out of terminal housing again.
Flat Connector System With Two Retaining Tabs:
