Eos (1F7) V6-3.2L (BUB) (2008)
-
Reinstall the wiring eyelet with the specified torque.
‹› Optimal contact is ensured if the bolted components are tightened to the specified torque after cleaning.
-
Apply protection material to the connection. Refer to => [ Protecting Connections ] See: Description and Operation/Protecting Connections.
Risk of injury. Observe warning notes and safety precautions. Refer to => [ Battery Safety Precautions ] See: Starting and
Charging/Battery/Service Precautions/Technician Safety Information/Battery Safety Precautions and => [ Battery Safety Designation ]
See: Starting and Charging/Battery/Service Precautions/Technician Safety Information/Battery Safety Designation!
-
Connect the battery.
-
Program the window regulators, enter the radio code, set the clock and, if necessary, recode control modules that have error messages.
Threaded Connections, Repairing
Threaded Connections, Repairing
Special tools, testers and auxiliary items required
‹› Torque Wrench 5-50nm (VAG1331)
Risk of injury. Observe warning notes and safety precautions. Refer to => [ Battery Safety Precautions ] See: Starting and
Charging/Battery/Service Precautions/Technician Safety Information/Battery Safety Precautions and => [ Battery Safety Designation ]
See: Starting and Charging/Battery/Service Precautions/Technician Safety Information/Battery Safety Designation!
‹› Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be exceeded when installing and this will lead
to the threaded connection breaking.
‹› The gray sanding pads are for slight contamination and suitable for "soft surfaces". The red sanding pads are for heavy contamination and suitable
for "hard surfaces".
-
Disconnect battery.
-
Loosen the cap nut and remove the wiring eyelet from the threaded connection.