Eos (1F7) V6-3.2L (BUB) (2008)
Information Bus: Removal and Replacement
Data Bus On Board Diagnostic Interface
Removing:
‹› If Data Bus On Board Diagnostic Interface (J533) is to be replaced, the work procedure to read out the codes stored in the module must always be
performed. Refer to => [ Data Bus On Board Diagnostic Interface ] See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Data
Bus On Board Diagnostic Interface.
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove cover in driver's side footwell.
-
Disengage harness connector - 1 - and disconnect it from Data Bus On Board Diagnostic Interface - 2 -.
-
Press mounting pins - 3 - together - arrows - and out of holes.
Installing:
Install in reverse order of removal.