Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Engine Control Module/Service
and Repair/Engine Control Module J623, Replacing.
-
Using a Multimeter, check the Heated Oxygen Sensor (HO2S) (G39) or the Heated Oxygen Sensor (HO2S) 2 (G108) electrical harness connector
terminals to the Engine Control Module (ECM) (J623) electrical harness connector T121 terminals for an open circuit.
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 04 - Erase DTC Memory
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code Description ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes.
-
End diagnosis.