Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-926005.png)
-
Tighten the M8 bolts - item 8 -=> [ Bolt ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block Assembly/Balance Shaft Chain/Service and
Repair to 23 Nm and tighten the M6 stud bolt - item 2 -=> [ Stud Bolt ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block
Assembly/Balance Shaft Chain/Service and Repair to 8 Nm.
-
Install the chain tensioner for the camshaft timing chain and tighten it to 40 Nm.
-
Install the cylinder head cover. Refer to => [ Cylinder Head Cover ] See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve
Cover/Service and Repair/Cylinder Head Cover.
-
Install the intake manifold. Refer to => [ Intake Manifold ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Intake
Manifold.
The rest of the installation is basically a reverse of the removal sequence.
