Eos (1F7) V6-3.2L (BUB) (2008)
-
Using a Multimeter, check the Fuel Injector electrical harness connector terminals to the Engine Control Module (ECM) (J623) electrical harness
connector T121 terminals for an open circuit.
Specified value: 1.5 ohms Max.
If the specification is not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring:
-
Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 04 - Erase DTC Memory
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code Description ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
-
End diagnosis.