Eos (1F7) V6-3.2L (BUB) (2008)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor
‹› Phased in introduction of fuel delivery units with changed fuel level sensor (G).
Removing (Old Version)
-
Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair.
-
Note the color of the wire for installation later.
-
Release the connectors - arrows - and remove the electrical wires - 1, 2 and 3 -. Bend the retaining hooks on the connector back.
-
Lift the retaining tabs - 4 and 5 - with a screwdriver and pull the fuel level sensor downward and off - arrow -.
Installing
-
Install the fuel level sensor in the guides on the fuel delivery unit and push upward until it engages.
-
Connect the connectors - 1 through 3 -. Note the color coding.
-
Pull on the connectors to make sure it is fastened securely.
-
Install the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair.
Removing (new Version)
-
Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair.
-
Pull the fuel level sensor slightly to the side and simultaneously upward.