Eos (1F7) V6-3.2L (BUB) (2008)
-
Operate the starter.
The LED should flicker.
-
Switch the ignition off.
If the LED flickers and the voltage was OK:
-
Replace the faulty Ignition Coils with Power Output Stage (N70, N127, N291, N292, N323, N324).
If the LED does not flicker:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/31).
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Computers and Control
Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Replacing.
-
Using a Multimeter, Check the Ignition Coil electrical harness connector to the Engine Control Module (ECM) (J623) electrical harness connector
T121 for an open circuit.