Eos (1F7) V6-3.2L (BUB) (2008)
Electronic Throttle Control Module: Service and Repair
Throttle Valve Control Module
Removing
-
Pull off air guide cover - 1 -, disengage clips sideways to do so.
-
Unclip air duct - 2 -.
-
Remove the air filter housing and connecting hose, while doing this remove the bolt - A -, disconnect the connector - B - and remove the spring
clip - C -. Pay attention to the marking - D - when reinstalling.
-
Disconnect electrical connection to Throttle Valve Control Module J338.
-
Remove Throttle Valve Control Module J338 from intake manifold - arrows -.
Installing
Installation is performed in the reverse order of removal, noting the following:
-
If a new Throttle Valve Control Module J338 was installed, adapt the engine control module to the Throttle Valve Control Module J338 "Guided
Functions".