Eos (1F7) V6-3.2L (BUB) (2008)
Engine Control Module: Service and Repair
Engine Control Module, Without Anti-Theft Immobilizer
Engine Control Module, without Anti-Theft Immobilizer
‹› If it is desired to replace the Engine Control Module (ECM), connect the vehicle diagnostic tester and perform the guided function " Replace
Engine Control Module (ECM)".
Removing
-
Turn off the ignition.
-
Remove the windshield wiper arms, plenum chamber cover and plenum chamber facing wall.
-
Disconnect the front connector - 1 - from the ECM.
-
Pry up the locking mechanism - 2 - slightly.
-
Slide the ECM out of the bracket in the - direction of the arrow -.
-
Disconnect the rear connector from the ECM.
Installing
-
Connect and lock the rear connector to the ECM.
-
Slide the ECM into the bracket.
-
Connect and lock the front connector to the ECM.
-
Install plenum chamber facing wall, plenum chamber cover and windshield wiper arms.