Eos (1F7) V6-3.2L (BUB) (2008)
Parking Assist Distance Sensor: Procedures
Sensor Bracket, Installing
Sensor Bracket, Installing
NOTE:
-
If a bumper cover is repaired or a new bumper cover is installed, the sensor brackets of the parking aid system must be glued into the marked
adhesive area provided for them on the inside of the bumper cover. Before bonding, the sensor brackets and sensors must be painted separately in
the color of the bumper cover. The following requirements must be observed when painting the sensor brackets and the sensors in order to ensure
full functionality of the parking aid system. Preparation of the adhesive contact surface and the adhesive process are to be performed while
observing the following process steps. Use the corresponding repair set.
-
Use the assembly instructions supplied in the repair kit.
Sensor Brackets and Sensors, Painting
Sensor Brackets and Sensors, Painting
Painting sensor brackets:
-
Remove grease from sensor brackets in the area to be painted - 1 - using isopropyl alcohol.
-
Paint sensor bracket in the area to be painted - 1 - in the color of the bumper cover.
NOTE:
-
The paint application dimension - A - must not cross over 2.5 mm into inside of sensor bracket.
-
Only apply paint on inside of sensor retainer in the area indicated. If this is not observed, it may lead to difficulty when assembling or
malfunctions in the parking aid system.
Painting sensor:
-
Remove decoupling ring (black silicon ring) from sensor head.
NOTE: Illustration shows the painting area on the sensor manufactured by "Valeo". Painting area on sensor manufactured by "Bosch" is
identical.
-
Remove grease from black sensor head - 1 - in the area to be painted - 2 - with isopropanol.
-
Paint sensor in the area to be painted - 2 - in the color of the bumper cover.
NOTE: Paint application dimension - B - is 3 mm (+ maximum 2 mm).