Eos (1F7) V6-3.2L (BUB) (2008)
-
Check whether the correct seal (coupling ring) is installed. It must be a black silicone ring - 1 -.
‹› The primary function of the coupling ring is a correct coupling between the sensor membrane and the sensor bracket. An additional function is
centering the sensor membrane in the corresponding sensor bracket.
-
Check sensor for correct seating. Dimension - a - must be even all around.
Rear Parking Aid Sensor, From 06.07
Special tools, testers and auxiliary items required
‹› Release tool (T10345)
The following four sensors are located in rear bumper cover.
‹› Left Rear Parking Aid Sensor (G203)
‹› Left Rear Center Parking Aid Sensor (G204)
‹› Right Rear Center Parking Aid Sensor (G205)
‹› Right Rear Parking Aid Sensor (G206)
‹› The procedure for the removal and installation of the parking aid sensors is performed in the same way for all sensors and is only described for one
sensor in the following.
Removing: