Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-197004.png)
-
Remove screw - 2 - and remove sensor - 1 - from striker pin - 4 -.
When replacing sensor, disconnect wire - 3 - approximately 130 mm from sensor, between cable brackets. After repairing wiring harness, wiring must
be secured in harness again.
Tightening specification for screw - 2 -: 3 Nm.
Rear Window Frame Opening Sensor
Rear Window Frame Opening Sensor
