volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Roof Pillar Front Position Sensors|Page 693 > < Roof Pillar Front Position Sensors|Page 691
Page 8
background image

-

Run roof with convertible top opening switch until rear lid with rear shelf is open halfway.

-

Remove screw - 2 - and remove sensor - 1 - from locking bracket - 4 -.

When replacing sensor, disconnect wire - 3 - approximately 350 mm from sensor, behind corner. After repairing wiring harness, wiring must be
secured in harness again.

Tighten screws - 2 -: 3 Nm.

Convertible Top Storage Sensor G565 Vehicles From VIN 8V036221

Convertible Top Storage Sensor G565 Vehicles from VIN 8V036221

‹› All screws are microencapsulated and must always be replaced.

Roof Pillar Front Position Sensors|Page 693 > < Roof Pillar Front Position Sensors|Page 691