Eos (1F7) V6-3.2L (BUB) (2008)
-
Disconnect harness connector - 2 - from ignition/starter switch - 1 -.
-
Release ignition/starter switch using a small screwdriver - arrows -.
-
Pull out ignition/starter switch - 1 - from steering lock housing.
Installing:
-
Insert ignition/starter switch into steering lock housing until it engages audibly.
-
Insert ignition key into lock cylinder and turn it into position Drive.
‹› Key must be located in Drive position.
Key positions of lock cylinder:
1
Position Off
2
Position Run
3
Position Start