Eos (1F7) V6-3.2L (BUB) (2008)
Headlamp Alignment Sensor: Service and Repair
Left Rear Level Control System Sensor G76
Left Rear Level Control System Sensor G76
Removing
-
Switch off ignition, switch off all electrical components and remove ignition key.
-
Disconnect connector - arrow -.
-
Remove mounting bolts - 1 - and remove Left Rear Level Control System Sensor G76 - 2 -.
Installing
Install in reverse order of removal, noting the following:
-
Tighten all threaded connections using the specified torques.
-
Check Left Rear Level Control System Sensor G76.
-
Perform basic setting of headlamp.
NOTE:
-
If the vehicle level sensors are replaced, the values of the sensor must be checked and basic setting of headlamps must be performed.
-
If values of vehicle level sensors are outside the tolerance range, basic setting of headlamps cannot be performed.