Eos (1F7) V6-3.2L (BUB) (2008)
‹› Crimping Pliers (Base Tool) (VAS 1978/1-2) in conjunction with exchangeable heads (VAS 1978/1-1) or (VAS 1978/2A) can also be used to
crimp the connections as an alternative. Refer to => [ Crimping Pliers VAS 1978/1A ] See: Crimping Pliers VAS 1978/1A.
‹› Always be sure to use the correct crimping slot for the crimping connection used.
‹› Do not crimp wire insulation.
Contact Release Tools
Contact Release Tools
Various release tools are used to remove the different terminals from terminal housings without damage.
A selection of release tools are a component of wiring harness repair kit (VAS 1978) and of wiring harness repair set (VAS 1978A). Release tool set
(VAS 1978/35) contains the entire set of release tools. Refer to => [ VAS 1978/35, Release Tool Set ] See: VAS 1978/35, Release Tool Set.
Some tools are supplied with a tool safety clip, which is slid over the tool points after using the tool, in order to protect other workers
from injuries and tool points from damage.
Releasing and disassembling terminal housings:
-
Secondary lock, refer to => [ Secondary Lock ] See: Secondary Lock.
-
Primary lock, refer to => [ Primary Lock ] See: Primary Lock
-
Round connector systems, refer to => [ Round Connector Systems ] See: Round Connector Systems
-
Flat connector systems, refer to => [ Flat Connector Systems ] See: Flat Connector Systems
-
Special connector systems, refer to => [ Special Connector Systems ] See: Special Connector Systems
Hot Air Gun VAS 1978/14
Hot Air Gun VAS 1978/14