Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1336002.png)
-
Put single wire seal - A - onto free end of repair wire.
‹› When doing this, small diameter of single wire seal must point toward contact housing.
-
Slide single wire seal - A - onto repair wire up to the contact housing.
-
Slide single wire seal - A - into contact housing until it stops using the corresponding assembly tool - B -.
-
Shorten the repair wire and the vehicle-specific wiring harness single wire as needed using the Wire Stripper (VAS 1978/3).
