volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Steering - Sensor Can't Be Adapted When Replacing Module|Page 5102 > < Steering - Update Software After Part Replacement|Page 5097
Page 1
background image

Steering Control Module: All Technical Service Bulletins
Steering - Sensor Can't Be Adapted When Replacing Module

48 08 02

May 29, 2008

2017881

Affected Vehicles

Condition

Steering Angle Sensor, Cannot be Adapted

Steering angle sensor cannot be adapted after the steering wheel electronics module -J527- has been replaced.

Technical Background

Production Solution

Not applicable.

Service

To verify the correct part has been received, the part number that is stamped on the case must be compared to part number recovered with the scan tool.

If a fault log has been printed since the part was installed:

^

Compare part number under "Steering Column Electronics" to component part number

If a fault log has not been printed since -J527- replacement, perform the following:

^

Select "Vehicle Self Diagnosis"

^

Select "On Board Diagnostics (OBD)"

^

Select "16 - Steering Wheel Electronics"

^

Review part number in upper right hand of screen to verify the index is Not "AM". If "AM" is shown, replace the -J527-.

Steering - Sensor Can't Be Adapted When Replacing Module|Page 5102 > < Steering - Update Software After Part Replacement|Page 5097