Eos (1F7) V6-3.2L (BUB) (2008)
‹› Make sure that the ball joint boot is not damaged or twisted.
-
Bolt universal joint to steering gear.
-
Connect battery.
-
Perform the steering angle sensor (G85) basic setting with the (VAS 5051).
If a new steering gear was installed, then the electromechanical steering must be adapted with the (VAS 5051).
-
Adapt the electromechanical steering with the (VAS 5051 ).
Suspension
Electro-mechanical Steering
01 - On-Board Diagnostic (OBD) Capable System
Electro-mechanical Steering
Functions
Adaption to Electro-mechanical Steering
After installation, position of steering wheel must be checked with a road test.
If steering wheel is at an angle or a new steering gear was installed, vehicle must be aligned.
‹› If parking assist 2 is installed in the vehicle, the power steering control module (J500) must be recoded after installing new steering gear using the
(VAS 5051)
‹› Parking assist 2 is only installed in vehicles with generation 2 steering gear.
Tightening Specifications