Eos (1F7) V6-3.2L (BUB) (2008)
-
Slide bellows - 2 - onto tie rod - 1 - as depicted in the illustration.
-
Secure spring clamp on bellows using (V.A.G 1275).
-
Slightly grease the sealing surface of the bellow to the steering gear housing with grease (G 052 168 A1) (from the repair kit, from Fuchs Renolit
JP1619).
-
Push the boot all the way onto the steering gear housing.
-
Tighten new clamp using (VAS 6199) to the extent depicted in the illustration.
Further installation is in the reverse sequence to removal.
For the wheel tightening specification, refer to => [ Wheel Bolt Tightening Specification ] See: Wheels and Tires/Wheel Fastener/Specifications.
After the installation the vehicle must be measured.
-
Perform vehicle alignment. Refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
-
Perform adaptation for steering angle sensor ( G85) via the Guided Fault Finding function with the (VAS 5051B).
-
Then perform steering system adaptation via the Guided Fault Finding function with the (VAS 5051B).
Tightening Specifications