Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the front wheels.
-
Remove lower noise insulation.
-
Disconnect the connector for the service interval extension to the oil pan.
-
Remove bracket for exhaust system from the subframe.
-
Remove coupling rods from stabilizer.
-
Remove nuts - arrows -.
-
Loosen nut of track rod ball joint, but do not unscrew yet.
‹› To protect thread, screw nut on pin a few turns.
-
Press off tie rod end from wheel bearing housing with ( 3287A) and then remove nut.