Eos (1F7) V6-3.2L (BUB) (2008)
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and
Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
5
Eccentric Washer
‹› Inner bore with tab.
6
Nut
‹› M12 x 1.5
‹› 95 Nm
‹› Self-locking
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and
Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
7
Subframe
8
Bolt
‹› M12 x 1.5 x 90
‹› 90 Nm + 90° turn
‹› Always replace after removal.
9
Lower Transverse Link
‹› Removing and installing, refer to => [ Lower Transverse Link ] See: Control Arm/Service and Repair/Removal and Replacement/Rear
Suspension/Lower Transverse Link.
10
Nut
‹› M12 x 1.5
‹› 90 Nm + 90° turn
‹› Self-locking
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and
Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
11
Bolt
‹› Always replace after removal.
12
Threaded Rivet
‹› M6
13
Expanding Rivet
14
Stone Protection Plate
15
Bolt
‹› 8 Nm