Eos (1F7) V6-3.2L (BUB) (2008)
16
Nut
‹› M14 x 1.5
‹› 130 Nm + 90° turn
‹› Self-locking
‹› Always replace after removal.
17
Washer
18
Bolt
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and
Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
19
Washer
20
Upper Transverse Link
‹› Removing and installing, refer to => [ Upper Transverse Link ] See: Control Arm/Service and Repair/Removal and Replacement/Rear
Suspension/Upper Transverse Link.
21
Washer
22
Nut
‹› M14 x 1.5
‹› 130 Nm + 90° turn
‹› Self-locking
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and
Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
23
Wheel Bearing Housing
‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Service and Repair/Removal and Replacement/Rear Suspension/Wheel
Bearing Housing.
24
Washer
25
Bolt
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and
Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
26
Tie Rod
‹› Various versions
‹› Closed in direction of travel (the right and left tie rods are different).
‹› Opened downward (the right and left tie rods are the same).
‹› It is possible to interchange.