Eos (1F7) V6-3.2L (BUB) (2008)
Only tighten bolts for longitudinal control arm/wheel bearing housing if all other components (especially spring and shock absorber) of appropriate
suspension are already installed. To tighten, suspension must be unladen. Only then will longitudinal control arm and wheel bearing housing move to
required position - arrows -.
The sequence of the following work steps must absolutely be observed!
^
Install bolt for tie rod - 1 -, upper transverse link - 2 - and lower transverse link - 3 - but do not tighten yet.
^
Install coupling rod - arrow - on wheel bearing housing hand-tight.
^
Install bolts - arrows - and insert connecting link - 1 - into trailing arm.
^
Tighten bolt - arrow - for shock absorber.
Only install bolted connections on wheel bearing housing if dimension "a" is reached!
^
Install coil spring.