Eos (1F7) V6-3.2L (BUB) (2008)
-
After installing, perform the basic setting on the steering angle sensor (G85) using the Vehicle Diagnostic, Testing and Information System (VAS
5051).
Stabilizer Bar
Stabilizer Bar
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1331)
Removing
‹› The following work steps are described for the left side of the vehicle. These work steps also apply simultaneously for right side of vehicle.
-
Remove the nut - 1 - and pull coupling rod - 2 - out of stabilizer.
‹› Do not loosen screw - arrow - on tie rod - 3 - on right side of vehicle.
-
Remove bolts - arrows - for stabilizer clamp.