Eos (1F7) V6-3.2L (BUB) (2008)
-
Replace the bracket bolts one after the other with (T10096 ) and tighten to 20 Nm.
Securing Console
Position of front axle is now secured.
Continue with removing stabilizer. Refer to => [ Remove the stabilizer from the subframe ] See: Stabilizer Bar/Service and Repair/Removal and
Replacement/Front Suspension/Stabilizer Bar.
Steering gear, generation 2, through MY 2008, removing and installing, refer to => [ Place the under the subframe. ] See: Steering/Steering
Gear/Service and Repair/Removal and Replacement/Steering Gear, Generation 2, Through MY 2008.
Steering gear, generation 3, from MY 2009, removing and installing, refer to => [ Place the under the subframe. ] .
Removing (T10096)
Removal is performed in the reverse order of installation. Make sure that the (T10096) are replaced one after the other with new bolts.
Tightening Specifications