Eos (1F7) V6-3.2L (BUB) (2008)
-
Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Testing and
Inspection/Programming and Relearning.
-
Perform a basic setting on the headlamps via the Guided Fault Finding function with the (VAS 5051).
Tightening Specifications
Left Rear Level Control System Sensor
Left Rear Level Control System Sensor
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1331)
‹› Vehicle Diagnosis, Testing, and Information System ( VAS 5051)
Removing
-
Disconnect the connector.
-
Remove the bolts.
-
Remove left rear level control system sensor ( G76).
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
The level control system sensor lever must point toward vehicle exterior.
-
Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Testing and
Inspection/Programming and Relearning.
-
Perform a basic setting on the headlamps via the Guided Fault Finding function with the (VAS 5051).
Tightening Specifications