Eos (1F7) V6-3.2L (BUB) (2008)
‹› Observe installation position!
The spring start - arrow - must touch bottom of spring seat.
-
Install spring together with spring seat.
-
Spring seat has a pin on bottom.
-
This pin is inserted into hole of lower transverse link - arrow -.
-
Then insert spring seat at top into upper spring end.
-
Relieve tension on spring, place upper spring seat onto tab of chassis when doing this.
-
Remove spring tensioner.
-
Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Wheels and Tires/Wheel Fastener/Specifications.
Shock Absorber and Coil Spring Assembly Overview
Shock Absorber and Coil Spring Assembly Overview
‹› Assembly overview, adaptive chassis DCC, refer to => [ Shock Absorber Assembly Overview ] See: Suspension Strut / Shock Absorber/Service
and Repair/Removal and Replacement/Shock Absorber Assembly Overview, Self-Leveling Suspension.